CM&E/Norman Model 50 16 Knife Trim Block Chipper or “overs” Rechipper

One (1) Used CM&E/Norman Model 50 (disc dia.) High Production Drop Feed, Top Discharge 16 Knife Trim Block Chipper or “overs” Rechipper. Direct coupled to 100HP, 900 RPM, 460Volt AC motor. Assembled on factory base. Typical output is 20 units (113.2 cubic meters) per hour. Spout measures 12” X 22”. Lineal feed rate is approximately 800 feet (244m) per minute. Disc was recently rebuilt and looks near new. Can blow chips up to 300 feet. Approximate weight is 12,000 lbs with motor and motor base. Dimensions with motor base are 9 ft. long X 7’10” wide. Wear parts are chrome plated. 1-Set of spare used wear parts are included. Spare disc available at additional cost. Chipper appears in good condition and was recently in service. Available due to mill closure. See photos of CM&E/Norman Model 50 (disc dia.) High Production Drop Feed, Top Discharge 16 Knife Trim Block Chipper or “overs” Rechipper on our web site. Inventory No. 12253. Located at our Portland, Oregon facility. For brochure click on View PDF View PDF

CM&E/Norman Model 50 16 Knife Trim Block Chipper or “overs” Rechipper

Click thumbnails below to view larger image:

Would you like more specific information?

Your Name: Phone Number:
Email Address: Fax Number:
Company Name: Address:
Are you a used equipment reseller?

 

Website Design & Hosting by Starbelly Designs